IPS FLANGE ADAPTOR 2 " 12" D. HOT HDPE  Only products bearing the NSF Mark on the product, product packaging, and/or documentation shipped with the product are Certified.  Certified for the following configurations: PN16, SDR11, and 20
Long radius bends normally have a radius of approximately three times the outside diameter of the pipe. Standard angles of elbows are: 90, 45 and 22.5 degrees. Dividers All ow dividers will cause change in ow direction and should therefore be properly anchored
9 IntegriFuse SDR 17 (Standard Dimension Ratio) 125 PSI (Working Pressure at 73.4˚ F) Nominal IPS Pipe Size A inches B inches C inches D inches E inches Weight lbs. Item Code 2” 90BI 2IPS 17 3” 4
Generally there are five types of PE flanges applied in butt welding: Weld neck flanges Slip on flanges Reducing Flanges Increaser Flanges Lap joint Flanges, Van Stone HDPE Flange types: 1. Flat face Flange : In this type one of the faces of flange, lying against Puhui Pipe manufacturer in China
 Configurations include: Male Adapter Threaded PN25 GFF 3220 (32 mm x 1/2") 90 Threaded Elbow PN25 CFF (20 mm x 1/2") CFF 2025 (20 mm x 3/4") CFF 2520 (25 mm x 1/2") CFF 2525 (25 mm x 3/4
Water: Water: Water Contact: Contact: Contact: Trade Designation: Size Restriction: Temp: Material: Coatings Fittings: 3M Scotchkote Fusion Bonded Epoxy Coating
Flange adapter with PE ends for electrofusion, PE 100 / Pressure rating Weight 5005017 Flange adapter with PE ends for electrofusion, PE 100 / SDR 17,6 PN 10 DN80/90 PN10 6.5 KG 5005019 Flange adapter with PE ends for electrofusion, PE 100 / SDR 17
NOTE: Unless otherwise indied for Materials, Certifiion is only for the Water Contact Material shown in the Listing. Click here for a list of Abbreviations used in these Listings. Click here for the definitions of Water Contact Temperatures denoted in these Listings.